Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 253

show ipv6 pim neighbor
show ipv6 pim remote-neighbor
Copyright © 2010, Juniper Networks, Inc.
host1#show ipv6 pim interface count
PIM Interface Count
Interface Addr Interface Name
::107:84 ATM3/0.20
See show ipv6 pim interface
Use to display information about PIM neighbors that the router discovered.
Provide an interface type and specifier (such as atm 3/0) to display information about
that interface only. For details about interface types and specifiers, see Interface Types
and Specifiers in JunosE Command Reference Guide.
Specify the detail keyword to view detailed information for all PIM neighbors or for a
specified PIM neighbor.
Field descriptions
Neighbor Addr—IPv6 address of the neighbor
Interface Name—Type and specifier of the interface to which the neighbor connects.
For details about interface types and specifiers, see Interface Types and Specifiers
in JunosE Command Reference Guide.
Uptime—Time since the router discovered this neighbor
Expires—Time available for the neighbor to send a hello message to the interface.
If the neighbor does not send a hello message during this time, it will no longer be a
neighbor.
Ver—Version of PIM that the neighbor is running
Mode—PIM mode that the neighbor is using: sparse
Example
host1#show ipv6 pim neighbor
PIM Neighbor Table
Neighbor Addr Interface Name
::107:48 atm2/1.109
::108:58 atm2/1.108
::111:98 atm2/0.110
See show ipv6 pim neighbor
Use to view information about PIM remote neighbors.
Field descriptions
Remote Nbr Addr—IPv6 address of remote neighbor
OurEnd Addr—IPv6 address of local interface, such as the local endpoint of a tunnel,
that transmits data to remote neighbor
Chapter 7: Configuring PIM for IPv6 Multicast
ControlPktCount In|Out
Hello JoinPrune Assert
0 0 0
0 0 0
Uptime Expires
1d15:47:35 00:01:41 2
1d15:47:34 00:01:42 2
1d15:48:02 00:01:44 2
Ver Mode
Sparse
Sparse
Sparse
231