Table of Contents
Advertisement
CHAPTER 4
Configuring DVMRP
Copyright © 2010, Juniper Networks, Inc.
E Series routers support Distance Vector Multicast Routing Protocol (DVMRP) on VRs
to forward multicast datagrams through a network. DVMRP is an interior gateway protocol
that supports operations within an autonomous system, but not between autonomous
systems. The multicast backbone of the Internet, MBone, uses DVMRP to forward
multicast datagrams. This chapter describes how to configure DVMRP on E Series routers;
it contains the following sections:
Overview on page 124
Platform Considerations on page 125
References on page 126
Before You Begin on page 126
Enabling DVMRP on a VR on page 126
Activating DVMRP on an Interface on page 127
Configuring DVMRP Limits on page 127
Filtering DVMRP Reports on page 128
Configuring DVMRP Summary Addresses on page 129
Changing the Metric for a Route on page 130
Importing Routes from Other Protocols on page 130
Specifying Routes to Be Advertised on page 131
Preventing Dynamic Route Distribution on page 132
Exchanging DVMRP Unicast Routes on page 132
Disabling and Removing DVMRP on page 133
Clearing DVMRP Routes on page 134
Configuring DVMRP Tunnels on page 134
Monitoring DVMRP on page 134
123
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 and is the answer not in the manual?
Questions and answers