Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 195

Copyright © 2010, Juniper Networks, Inc.
See show ipv6 mroute command for descriptions of all fields except the statistics
field.
Statistics
NOTE: The display shows statistics after the VR has added the multicast
route to the multicast routing table and established the route on the
appropriate line module. Statistics for interactions before the route is
established on the line module are not displayed.
Received—Number of packets and bytes that the VR received for this multicast
route
Forwarded—Number of packets and statistics that the VR has forwarded for this
multicast route
Rcvd on OIF—Number of packets and statistics that the VR has received on the
OIF for this multicast route
Example
host#show ipv6 mroute statistics
IPv6 Multicast Routing Table
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(10:0:0:1:1::, ff0e::1) uptime 0 01:05:23
Admission bandwidth:
RPF route: 10:0:0:1::/64, incoming interface ATM2/3.1001
neighbor 10:0:0:1::1, owner Local
Incoming interface list:
ATM2/3.1001 (10:0:0:1::1/64), Accept/Pim (RPF IIF)
Outgoing interface list:
ATM2/0.200 (21:2:2:21::2:1/60), Forward/Pim, 0 01:05:23/never
Statistics:
Received : 346 pkts, 22144 bytes
Forwarded : 346 pkts, 22144 bytes
Rcvd on OIF: 0 pkts
(10:0:0:1:2::, ff0e::1) uptime 0 01:05:23
RPF route: 10:0:0:1::/64, incoming interface ATM2/3.1001
neighbor 10:0:0:1::1, owner Local
Incoming interface list:
ATM2/3.1001 (10:0:0:1::1/64), Accept/Pim (RPF IIF)
Outgoing interface list:
ATM2/0.200 (21:2:2:21::2:1/60), Forward/Pim, 0 01:05:26/never
Statistics:
Received : 346 pkts, 22144 bytes
Chapter 5: Configuring IPv6 Multicast
173