Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 222

JunosE 11.3.x Multicast Routing Configuration Guide
show ipv6 mld interface brief
host1:boston# show ipv6 mld interface brief
Interface Intf Address
--------------- --------------- --- ---------- ------------- ------ ------
ATM2/0.103 130.0.0.1/24
ATM5/0.102 131.0.0.1/24
Counts: 0 down, 0 init state, 2 querier, 0 non-querier, 2 Total
show ipv6 mld mapped-oif
200
Counts: 0 down, 0 init state, 1 querier, 0 non-querier, 1 Total
See show ipv6 mld interface.
Use to display a summary of MLD information for interfaces on which you enabled
MLD.
Field descriptions
Interface—Type of interface and interface specifier. For details about interface types
and specifiers, see Interface Types and Specifiers in JunosE Command Reference
Guide.
Intf Address—IPv6 link-local address of the interface
Ver—MLD version
State—Function of the interface: querier or nonquerier
Querier—IPv6 address of the querier on the network to which this interface connects
QTime—Remaining time interval at which this interface sends query messages
QPTime—Remaining time that the interface waits before declaring itself as the
querier
Example
Ver State
2 Querier 130.0.0.1
2 Querier 130.0.0.1
See show ipv6 mld interface.
Use to display the current mappings to all mapped outgoing interfaces or to the
specified mapped outgoing interface.
Field descriptions
OIF—Outgoing interface used in an OIF map
Oper—Operation status of the outgoing interface
Group Address—Multicast group IP address associated with the OIF
Source Address—Source IP address associated with the OIF
Join I/F—MLD protocol interface associated with the OIF
Querier QTime QPTime
3(7) 0
101(7) 0
Copyright © 2010, Juniper Networks, Inc.