Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 217

baseline ipv6 mld
show ipv6 mld
Copyright © 2010, Juniper Networks, Inc.
NOTE: The E120 and E320 routers output for monitor and show commands
is identical to output from other E Series routers, except that the E120 and
E320 routers output also includes information about the adapter identifier
in the interface specifier (slot/adapter/port).
Use to set the counters for MLD statistics to zero.
Example
(host1)#baseline ipv6 mld
There is no no version.
See baseline ipv6 mld.
Use to display MLD information for a VR.
Field descriptions
Administrative state—Status of MLD in the software: enabled or disabled
Operational state—Status of MLD on the VR: enabled or disabled
total interfaces—Number of interfaces on which you started MLD
enabled—Number of interfaces on which MLD is enabled
disabled—Number of interfaces on which MLD is disabled
learnt groups—Number of multicast groups that the VR has discovered
MLD Statistics Rcvd—Statistics for MLD messages received
total—Number of MLD messages received
checksum errors—Number of MLD messages received with checksum errors
unknown types—Number of messages received that are not multicast listener
queries, multicast listener reports, or multicast listener done messages
discards—Number of multicast listener discards
queries—Number of multicast listener queries
reports—Number of multicast listener reports
leaves—Number of done messages
MLD Statistics Sent—Number of multicast listener queries sent
Example
Chapter 6: Configuring Multicast Listener Discovery
195