Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 135

show ip pim data-mdt
Copyright © 2010, Juniper Networks, Inc.
Example 3—On a router that is not a candidate BSR
host1:1#show ip pim bsr
This PIM router is not a Candidate BSR.
Elected BSR is 101.0.0.1 (priority 0), expires in 73 seconds.
See show ip pim bsr.
Use to display information about active data MDTs.
To display information about data MDTs on which the provider edge transmits data,
use the sender keyword.
To display information about data MDTs on which the provider edge receives data,
use the receiver keyword.
To display information about an IP PIM group address pool, use the group keyword.
To display a summary of configuration for each data MDT, use the summary keyword.
To display the number of data MDTs, use the count keyword.
Field descriptions
PE Name—Name of the PE
C-SG—Address of the C-SG
P-SG—Address of the P-SG
MTI—Name of the dynamic IP tunnel on which the data MDT was created
Data rate/Threshold—Rate and threshold of multicast data
Time until next MDT Join TLV—Configured delay until next MDT Join TLV
Time until MDT Join TLV expires—Configured delay until MDT Join TLV expires
Time until switchover from default-MDT—Configured delay until the data MDT
switches over to the default MDT
Example 1—Displays information about a data MDT sender
host1:PE1#show ip pim data-mdt 225.1.1.1
PE11 - Sender
C-SG: 10.11.0.100, 225.1.1.1
P-SG: 1.1.1.1, 235.0.1.1
MTI: TUNNEL gre:mvpn-dynamic-1
Data rate/Threshold: 10012/500 Kbps
Time until next MDT Join TLV: 25 seconds
Example 2—Displays information about a data MDT receiver
host1:PE1#show ip pim data-mdt 225.2.2.2
PE31 - Receiver
C-SG: 10.13.0.100, 225.2.2.2
P-SG: 3.3.3.3, 235.0.1.1
MTI: TUNNEL gre:mvpn-dynamic-3
Time until MDT Join TLV expires: 29 seconds
Chapter 3: Configuring PIM for IPv4 Multicast
113