Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 55

show ip mroute active
show ip mroute count
Copyright © 2010, Juniper Networks, Inc.
Use to display the active multicast routes with admission bandwidth greater than the
specified bandwidth threshold.
The default is 4000 bps.
Field descriptions
See the show ip mroute command and the show ip mroute summary command
for descriptions of all fields.
Example 1—Displays active multicast routes with bandwidth above 10000 bps
host1#show ip mroute active 10000
Active IP Multicast Routes >=10000 bps
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(52.0.0.1, 232.0.0.1) uptime 0 00:01:07
Admission bandwidth: 47000 bps (adaptive)
QoS bandwidth: 47000 bps (adaptive)
RPF route: 52.0.0.0/24, incoming interface ATM2/1.17
neighbor 17.0.0.2, owner NetmgmtRpf
Incoming interface list:
ATM2/1.17 (17.0.0.2/24), Accept/Igmp (RPF IIF)
Outgoing interface list:
NULL
Counts: 1 (S, G) entries
0 (*, G) entries
Example 2—Displays the summary of active multicast routes
host1#show ip mroute summary active
Active IP Multicast Routes >=4000 bps
Group Address Source Address
--------------- --------------- ------------------ --------------- -----
232.0.0.1 51.0.0.1
232.0.0.2 51.0.0.1
232.0.0.3 51.0.0.1
Counts: 3 (S, G) entries
0 (*, G) entries
See show ip mroute.
Use to display information about the number of groups and sources.
Specify a multicast group address or both a multicast group address and a multicast
source address to display information about a particular multicast forwarding entry.
Chapter 1: Configuring IPv4 Multicast
RPF route RPF Iif
51.0.0.0/24 ATM3/1.17
51.0.0.0/24 ATM3/1.17
51.0.0.0/24 ATM3/1.17
#Oifs
0
0
0
33