Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 193

show mroute port count
Copyright © 2010, Juniper Networks, Inc.
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(52::1, ff3e::1) uptime 0 00:01:07
Admission bandwidth: 47000 bps (adaptive)
QoS bandwidth: 47000 bps (adaptive)
RPF route: 52::/112, incoming interface ATM2/1.17
neighbor 17::2, owner NetmgmtRpf
Incoming interface list:
ATM2/1.17 (fe80::90:1a00:3140:1ff8/128), Accept/MLD (RPF IIF)
Outgoing interface list:
NULL
Counts: 1 (S, G) entries
0 (*, G) entries
Example 2—Displays the summary of active multicast routes
host1#show ipv6 mroute summary active
Active IP Multicast Routes >=4000 bps
Group Address Source Address
--------------- ------------ ----------- --------- -----
232.0.0.1 51.0.0.1
232.0.0.2 51.0.0.1
232.0.0.3 51.0.0.1
Counts: 3 (S, G) entries
0 (*, G) entries
See show ipv6 mroute.
Use to display the mroute port outgoing interface, limits, and counts.
NOTE: This command displays information for mroutes on a port across
all virtual routers.
Field descriptions
Chapter 5: Configuring IPv6 Multicast
RPF route RPF Iif #Oifs
51.0.0.0/24 ATM3/1.17
51.0.0.0/24 ATM3/1.17
51.0.0.0/24 ATM3/1.17
0
0
0
171