Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 243

query-interval
remote-neighbor
update-source
Configuration Example
Copyright © 2010, Juniper Networks, Inc.
host1(config-router-rn):boston#query-interval 40
Repeat Steps 2 to 3 for the other router.
4.
Use to specify how often the router sends hello messages to remote neighbors.
Example
host1(config-router-rn)#query-interval 40
Use the no version to restore the default setting, 30 seconds.
See query-interval.
Use to specify a remote neighbor for PIM sparse mode.
Specify the IP address of the interface on the remote neighbor that PIM uses as the
source address for the connection to this router.
Example
host1(config-router)#remote-neighbor 1001::1 sparse-mode
Use the no version to remove the remote neighbor and any attributes configured for
the remote neighbor.
See remote-neighbor.
Use to specify the PIM interface whose local address is used as the source address for
the PIM connection to a remote neighbor.
You can use the same source address to form neighbor adjacencies with more than
one PIM remote neighbor.
You must use the IPv6 address of this interface when issuing the remote-neighbor
command on the remote neighbor.
Example
host1(config-router-rn)#update-source loopback 5
Use the no version to delete the source address from the connection to the remote
neighbor.
This example uses the configuration shown in Figure 21 on page 212. Two E Series routers
called router Boston and router Chicago are running PIM and are connected by MPLS
tunnels. To configure the routers as PIM remote neighbors:
Specify that router Chicago will be a remote neighbor of router Boston, and identify
1.
the IP address on router Chicago that will transmit datagrams to router Boston.
boston(config-router)#remote-neighbor 1001::1 sparse-mode
Chapter 7: Configuring PIM for IPv6 Multicast
221