Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 140

JunosE 11.3.x Multicast Routing Configuration Guide
show ip pim rp-hash
show ip pim sparse-mode sg-state
118
RP 122.0.0.1, priority 0,
Group(s) 224.0.1.40/32 (negative)
RP 122.0.0.1, priority 0,
Example 2
host1:8#show ip pim rp mapping
PIM Group-to-RP mapping(s)
Group(s) 224.0.0.0/4
RP 134.0.0.1, priority 0, via Static, from access-list 1
Group(s) 232.0.0.0/16
RP 134.0.0.1, priority 0, via BSR, expires in 121 seconds
See show ip pim rp.
Use to show which RP router that a multicast group is using.
Field descriptions
Group(s)—Multicast group or groups
RP—RP router for the multicast group
priority—Priority of the router
via—Method by which the RP router was assigned: AutoRP, Static RP, or BSR
expiryTime—Time in seconds at which the RP mapping becomes invalid, unless it is
renewed by the mapping agent
Example 1
host1:2#show ip pim rp-hash 232.1.1.1
Group(s) 224.0.0.0/4
RP 122.0.0.1, priority 0,
Example 2
host1:2#show ip pim rp-hash 226.0.0.1
Group(s) 226.0.0.0/24
RP 101.0.0.1, priority 192, via BSR, expires in 145 seconds
*RP 145.0.0.3, priority 192, via BSR, expires in 145 seconds
See show ip pim rp-hash.
Use to display information for each (S,G) pair for PIM sparse mode and PIM SSM.
Field descriptions
(S, G) pair—Source, Group pair for which information is provided
Group-to-RP mapping—IP addresses and network mask of the multicast group
RP—IP address of RP router
SSM group—Indicator that this is an SSM group
via AutoRP (Negative), expiryTime 88
via AutoRP (Negative), expiryTime 88
via AutoRP, expiryTime 128
Copyright © 2010, Juniper Networks, Inc.