Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 89

show ip igmp mapped-oif
Copyright © 2010, Juniper Networks, Inc.
Use to display a summary of IGMP information for interfaces on which you enabled
IGMP.
Field descriptions
Interface—Type of interface and interface specifier. For details about interface types
and specifiers, see Interface Types and Specifiers in JunosE Command Reference
Guide.
Intf Address—IP address of the interface
Ver—IGMP version
State—Function of the interface: querier or nonquerier
Querier—IP address of the querier on the network to which this interface connects
QTime—Time interval, in seconds, at which this interface sends query messages
QPTime—Time in seconds that the interface waits before declaring itself as the
querier
Count—Total number of IGMP interfaces
Example
host1:boston# show ip igmp interface brief
Interface Intf Address
-------------- ----------
fastEthernet0/0 192.168.1.250/24
atm3/0.2 21.1.1.1/8
Count: 2 interfaces
See show ip igmp interface.
Use to display the current mappings to all mapped outgoing interfaces or to the
specified mapped outgoing interface.
Field descriptions
OIF—Outgoing interface used in an OIF map
Oper—Operation status of the outgoing interface
Group Address—Multicast group IP address associated with the OIF
Source Address—Source IP address associated with the OIF
Join I/F—IGMP interface associated with the OIF
Map Name—Name of the map associated to the OIF
Counts—Number of source-group mappings to OIFs
Example
Chapter 2: Configuring IGMP
Ver State Querier
--- ------ -------------
2 Querier 192.168.1.250
2 Querier 21.1.1.1
QTime QPTime
----- ---
28 0
26 0
67