Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 141

Copyright © 2010, Juniper Networks, Inc.
RPF Route—IP address and network mask of the RPF route
IIF—IP address of the incoming interface for the RPF route
UpNbr—IP address of the upstream neighbor
Oifs—Outgoing interface
Auto RP Discovery SELF oif—Indicates that RP router for this group was assigned
through auto-RP
Register Oif to RP—IP address of RP router for the outgoing interface; suppressed
for SSM
Address—IP address of outgoing interface
Interface—Type and specifier of the interface. For details about interface types and
specifiers, see Interface Types and Specifiers in JunosE Command Reference Guide.
Joined as—Type of mapping
(S, G)—Mapping from a specific source to a specific group
(* , G)—Mapping from any source to a specific group
(* , * , RP)—Mapping from any source to any group
Join expires—Number of seconds before the (S,G) membership expires
Count of entries—Total counts of (S,G) pair mappings
Example
host1:2# show ip pim sparse-mode sg-state
<*, 224.0.1.40>
Group-to-RP mapping: 224.0.0.0/240.0.0.0
RPF Route: 123.0.0.0/255.0.0.0
Oifs:
Auto RP Discovery SELF oif.
Joined as <*, G>
<*, 225.1.2.3>
Group-to-RP mapping: 224.0.0.0/240.0.0.0
RPF Route: 123.0.0.0/255.0.0.0
Oifs:
Address: 78.7.7.7
Local group membership present.
<*, 235.1.1.1>
Group-to-RP mapping: 224.0.0.0/240.0.0.0
RPF Route: 123.0.0.0/255.0.0.0
Oifs:
Address: 78.7.7.7
Local group membership present.
<118.1.33.34, 232.0.0.1>
SSM Group
RPF Route: 118.1.0.0/255.255.0.0
Oifs:
Register Oif to RP: 141.0.0.2 suppressed for SSM Group.
Address: 134.0.0.1
Joined as <S, G>
Chapter 3: Configuring PIM for IPv4 Multicast
RP: 123.0.0.1
IIF: 106.0.7.3
RP: 123.0.0.1
IIF: 106.0.7.3
Interface: loopback7
RP: 123.0.0.1
IIF: 106.0.7.3
Interface: loopback7
IIF: 118.1.0.1 (Directly attached)
Interface: ATM3/0.104
Join Expires: 161
UpNbr: 106.0.3.7
UpNbr: 106.0.3.7
UpNbr: 106.0.3.7
119