Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 60

JunosE 11.3.x Multicast Routing Configuration Guide
show ip multicast routing
show mroute port count
38
For IGMP—Local
Count—Number of multicast protocols on the VR
Example
host1#show ip multicast protocols brief
Protocol Registered
Interfaces
--------- ----------
Pim 2
Igmp 1
Count: 2 protocols
See show ip multicast protocols.
Use to display information about the status of IP multicast on the VR.
Example
host1#show ip multicast routing
Multicast forwarding is enabled on this router
Multicast graceful restart is complete (timer 0 seconds) on this router
Multicast cache-miss processing is enabled on this router
See show ip multicast routing.
Use to display the mroute port outgoing interface, limits, counts, bandwidth settings,
and bandwidth accepted.
NOTE: This command displays information for mroutes on a port across
all virtual routers.
Field descriptions
Port—Slot/port value on the router
Limit—Port limit value defined for the specified port; -l indicates that no mrout port
limits have been configured for the port
Count—Number of mroute outgoing interfaces on the specified port
BW bps—Bandwidth limit, in bits per second
Priority BW bps—Priority bandwidth limit, in bits per second
Admitted—Bandwidth admitted on the port, in bits per second
Example
Owned Type
Interfaces
---------- -------------------
2 Sparse Dense
0 Local
Copyright © 2010, Juniper Networks, Inc.