Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 137

show ip pim interface
Copyright © 2010, Juniper Networks, Inc.
RPF Route: 121.0.0.0/255.0.0.0
Pruned Oifs:
Address: 108.0.8.5
Pruned due to assert
Pruned time remaining 133
See show ip pim dense-mode sg-state.
Use to display information about PIM interfaces.
Specify no keywords or variables to view information about all PIM interfaces.
Provide an interface type and specifier (such as atm 3/0) to display information about
that interface only. For details about interface types and specifiers, see Interface Types
and Specifiers in JunosE Command Reference Guide.
Specify the summary keyword to view the number of configured, enabled, and disabled
PIM dense mode, PIM sparse mode, and PIM sparse-dense mode interfaces.
Specify the count keyword to view the number of multicast packets that the interface
has sent and received.
Field descriptions
Interface Addr—IP address of the interface
Interface Name—Type and specifier of the interface. For details about interface types
and specifiers, see Interface Types and Specifiers in JunosE Command Reference
Guide.
Ver—Version of PIM running on this interface
Mode—PIM mode running on this interface: Sparse, Dense, or SparseDense
Nbr Count—Number of neighbors connected to this interface
Hello Intvl—Time interval, in seconds, at which the interface sends hello messages
to neighbors
J/P Interval—Time interval, in seconds, at which the interface sends the join/prune
messages
DR Addr—Address of the designated router
SM—Number of PIM sparse mode interfaces
DM—Number of PIM dense mode interfaces
SM/DM—Number of PIM sparse-dense mode interfaces
enabled—Number of interfaces administratively enabled
disabled—Number of interfaces administratively disabled
Chapter 3: Configuring PIM for IPv4 Multicast
IIF: 107.0.8.4
IfId: 95
UpNbr: 107.0.4.8
115