Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 56

JunosE 11.3.x Multicast Routing Configuration Guide
show ip mroute statistics
34
Field descriptions
Counts—Number of types of source group mappings
(S, G)—Number of (S,G) entries
(* , G)—Number of (* ,G) entries
Example
host1#show ip mroute count
IP Multicast Routing Table
Counts: 2 (S, G) entries
0 (*, G) entries
See show ip mroute.
Use to display statistics for packets received through multicast routes that the router
has added to the multicast routing table and established on the appropriate line
modules.
Specify a multicast group IP address or both a multicast group IP address and a
multicast source IP address to display information about a particular multicast
forwarding entry.
Field descriptions
See the show ip mroute command for descriptions of all fields except the Statistics
field.
Statistics
NOTE: The display shows statistics after the VR has added the multicast
route to the multicast routing table and established the route on the
appropriate line module. Statistics for interactions that take place before
the route is established on the line module are not displayed.
Received—Number of packets and bytes that the VR received for this multicast
route
Forwarded—Number of packets and bytes that the VR has forwarded for this
multicast route
Rcvd on OIF—Number of packets that the VR has received on the outgoing interface
(OIF) for this multicast route
Example
host1#show ip mroute statistics
IP Multicast Routing Table
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
Copyright © 2010, Juniper Networks, Inc.