Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 257

show ipv6 pim spt-threshold
Copyright © 2010, Juniper Networks, Inc.
Pref—Preference for the unicast route
Metric—Value of metric for the unicast route (type of metric varies with the unicast
protocol)
Count of entries—Number of unicast routes that PIM sparse mode is using.
Example
host1:2#show ipv6 pim sparse-mode unicast-route
PIM SM unicast route table information
Route
---------------------------------------------------------------------------
::122:0 /96
Count of entries: 1
See show ipv6 pim sparse-mode unicast-route
Use to display the threshold for switching to the shortest path tree at a PIM designated
router.
Field descriptions
Access List Name—Name of the IPv6 access list that specifies the groups to which
the threshold applies
SptThreshold (in kbps)—Value at which PIM sparse mode should switch from a
shared tree to an SPT. A value of infinity indicates that PIM sparse mode should
never switch to an SPT.
Example
host1:2#show ipv6 pim spt-threshold
Access List Name
-------------------------------------------------------
1
See show ipv6 pim spt-threshold.
Chapter 7: Configuring PIM for IPv6 Multicast
RpfNbr Iif
::122:1
SptThreshold(in kbps)
infinity
Pref Metric
255 1
235