Table of Contents
Advertisement
ipv6 rpf-route
Displaying Available Routes for Reverse-Path Forwarding
show ipv6 rpf-route
Copyright © 2010, Juniper Networks, Inc.
Use to customize static routes that the router may use for RPF.
Specify the IPv6 address and subnet mask of the destination network.
Specify either a next-hop IPv6 address or an interface type and specifier, such as
atm 3/0. For details about interface types and specifiers, see Interface Types and
Specifiers in JunosE Command Reference Guide.
Optionally, specify the distance (number of hops) to the next-hop address.
Example
host1(config)#ipv6 rpf-route 1000::/64 ATM2/1.200
Use the no version to remove the static route.
See ipv6 rpf-route.
Use the show ipv6 rpf-route command to display all available routes, only the routes to
a particular destination, or routes associated with a specific unicast protocol that the
router can use for Reverse-Path Forwarding (RPF).
Use to display routes that the router can use for RPF.
Specify the IPv6 address and the network mask to view routes to a particular
destination.
Specify the detail keyword to view more detailed information about routes to a
particular destination.
Specify a unicast routing protocol to view routes associated with that protocol.
Field descriptions
Protocol/Route type codes—Protocol and route type codes for the table that follows
Prefix—Value of the logical AND of the IPv6 address of the destination network and
the subnet address
Length—Length of the subnet mask in bits
Type
Connect—Subnet directly connected to the interface
Static—Static route
Dst—Distance configured for this route
Chapter 5: Configuring IPv6 Multicast
147
Advertisement
Table of Contents
