Preventing Dynamic Route Distribution; Exchanging Dvmrp Unicast Routes - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual

Software for e series broadband services routers multicast routing configuration guide
Table of Contents

Advertisement

JunosE 11.3.x Multicast Routing Configuration Guide

Preventing Dynamic Route Distribution

disable-dynamic-redistribute

Exchanging DVMRP Unicast Routes

ip dvmrp unicast-routing
132
Use the no version to enable the interface to advertise all DVMRP routes that it has
learned.
See ip dvmrp announce-filter.
By default, if you make changes to a route map, the router dynamically redistributes the
routes in DVMRP. To prevent this dynamic redistribution, use the
disable-dynamic-redistribute command.
Use to halt the dynamic redistribution of routes that are initiated by changes to a route
map; dynamic redistribution is enabled by default.
Example
host1(config-router)#disable-dynamic-redistribute
There is no no version.
See disable-dynamic-redistribute.
DVMRP maintains its own unicast routing table, based on distance vector calculations.
The routing table defines the best-known distance to each destination and how to get
there. The router updates the table by exchanging information with its neighbors. The
DVMRP routing table is used solely for RPF lookups.
By default, if DVMRP owns an interface, that interface exchanges DVMRP unicast routes
with its neighbors, and you cannot disable the exchange of routes. However, you can
enable and disable the exchange of DVMRP unicast routes on interfaces that DVMRP
does not own.
When an interface exchanges DVMRP routes, the router obtains routes from DVMRP
report messages and stores them in its DVMRP routing table. Other multicast protocols,
such as PIM, can then use these routes for RPF lookups. With this feature, PIM can use
the DVMRP routing table even when the router is not running DVMRP.
All interfaces, including tunnels, support DVMRP unicast routing. DVMRP tunnels use
DVMRP multicast routing to support DVMRP unicast routing.
Use to enable the exchange of DVMRP unicast routes on an interface not owned by
DVMRP.
Example
host1:boston(config-if)#ip dvmrp unicast-routing
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Junose 11.3

Table of Contents