Table of Contents
Advertisement
router igmp
Monitoring IGMP
baseline ip igmp
show ip igmp
Copyright © 2010, Juniper Networks, Inc.
Use to disable IGMP on a VR.
Example
host1(config)#virtual-router boston
host1:boston(config)#router igmp
host1:boston(config-router)#igmp disable
Use the no version to enable IGMP on a VR.
See igmp disable.
Use to create and enable IGMP on a VR or to access IGMP Router Configuration mode.
Example
host1(config)#virtual-router boston
host1:boston(config)#router igmp
Use the no version to remove IGMP and the IGMP proxy from the VR.
See router igmp.
You can establish a reference point for IGMP statistics by setting the statistics counters
to zero.
To display IGMP parameters, use the show commands described in this section.
NOTE: The E120 and E320 routers output for monitor and show commands
is identical to output from other E Series routers, except that the E120 and
E320 routers output also includes information about the adapter identifier
in the interface specifier (slot/adapter/port).
Use to set the counters for IGMP statistics to zero, to establish a baseline.
Example
(host1)#baseline ip igmp
There is no no version.
See baseline ip igmp.
Use to display IGMP information for a VR.
Field descriptions
Routing Process—Routing process for this VR (IGMP)
Administrative state—Status of IGMP in the software: enabled or disabled
Chapter 2: Configuring IGMP
61
Advertisement
Table of Contents
