Table of Contents
Advertisement
JunosE 11.3.x Multicast Routing Configuration Guide
Removing PIM
router pim
Resetting PIM Counters and Mappings
clear ip pim auto-rp
clear ip pim interface count
108
multiplier value is roughly equivalent to the number of packets that can be missed
before the BFD session is declared to be down. The default value is 3.
For details on liveness detection negotiation, see Negotiation of the BFD Liveness
Detection Interval in the JunosE IP Services Configuration Guide.
You can change the BFD liveness detection parameters at any time without stopping
or restarting the existing session; BFD automatically adjusts to the new parameter
value. However, no changes to BFD parameters take place until the values resynchronize
with each neighbor.
Example
host1(configif)#ip pim bfd-liveness-detection minimum-interval 800
Use the no version to disable BFD on the PIM interface.
See ip pim bfd-liveness-detection.
To remove PIM from a VR, use the no router pim command.
Use to create and enable PIM processing on a VR or to access Router Configuration
mode.
Example
host1:boston(config)#router pim
Use the no version to remove PIM from the VR.
See router pim.
You can use the clear ip pim commands to reset PIM counters and mappings.
Use to clear the group-to-RP router mappings that the router learned through auto-RP.
Specify the IP address of an RP to clear the group-to-RP mappings for a particular RP.
If you do not specify an IP address, the router clears the group-to-RP mappings on all
RP routers learned through auto-RP.
Example
host1#clear ip pim auto-rp 192.34.56.7
There is no no version.
See clear ip pim auto-rp.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
