Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 221

Copyright © 2010, Juniper Networks, Inc.
Interface statistics Sent—Number of MLD messages this interface has sent
Interface statistics Groups learnt—Number of groups this interface has discovered
Counts—Total number of MLD interfaces
Example
host1:boston#show ipv6 mld interface
Interface ATM2/0.103 address 13.0.0.1/255.255.255.0
Administrative state enabled, Operational state enabled
Interface parameters:
Version 2
State Querier
Query Interval 125 secs, 125 secs before the next query
Other querier present interval 250 secs
Maximum response time 255 (in 10ths of a second)
Last member query interval 10 (in 10ths of a second)
Robustness 3
No inbound access group
No inbound access source-group
No inbound apply-oif-map
Immediate Leave: disabled
Explicit Host Tracking: enabled
Max-Group limit: No Limit
Admission-Bandwidth limit: No limit
IOA Packet Replication: None
Group Count: 1
Interface statistics:
Rcvd: 2 reports, 0 leaves, 0 wrong version queries
Sent: 2 queries
Groups learnt: 1
Counts: 0 down, 0 init state, 1 querier, 0 non-querier, 1 Total
Example 2
host1#show ipv6 mld interface gigabitEthernet 3/0.0
Interface GigabitEthernet3/0.0 address 10.1.1.1/255.255.255.0
Administrative state enabled, Operational state enabled
Interface parameters:
Version 1
State Querier
Query Interval 125 secs, 123 secs before the next query
Other querier present interval 250 secs
Maximum response time 100 (in 10ths of a second)
Last member query interval 10 (in 10ths of a second)
Robustness 3
No inbound access group
No inbound access source-group
No inbound apply-oif-map
Immediate Leave: disabled
Explicit Host Tracking: enabled
Max-Group limit: No Limit
Group Count: 0
IOA packet replication gigabitEthernet 3/8.1
Interface statistics:
Rcvd: 0 reports, 0 leaves, 0 wrong version queries
Sent: 14 queries
Groups learnt: 0
Chapter 6: Configuring Multicast Listener Discovery
199