Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 197

Copyright © 2010, Juniper Networks, Inc.
Use to display information about multicast protocols enabled on the router.
Use the brief option to display a summary of information rather than a detailed
description.
Field descriptions
Protocol—Name of the multicast protocol
Type—Mode of the multicast protocol
For PIM—Sparse
For MLD—Local
Interfaces
registered—Number of interfaces on which the protocol is configured
owned—Number of interfaces that a protocol owns. If you configure only MLD on
an interface, MLD owns the interface. However, if you configure MLD and PIM on
the same interface, PIM owns the interface.
Registered interfaces—Includes the following information about interfaces on which
the protocol is configured
Types and identifiers of interfaces. For details about interface types and specifiers,
see Interface Types and Specifiers in JunosE Command Reference Guide .
Protocols configured on the interface and the protocol that owns the interface. If
you configure only MLD on an interface, MLD owns the interface. However, if you
configure MLD and PIM on the same interface, PIM owns the interface.
Admitted bandwidth / configured admission bandwidth (in bps)
Number of blocked OIFs
QoS adjustment bandwidth (in bps)
Count—Number of multicast protocols on the VR
Example
host1:2#show ipv6 multicast protocols
Multicast protocols:
Protocol Pim
Type: Sparse
Interfaces: 1 registered, 1 owned
Registered interfaces:
ATM2/1.103 (21:2:2:22::1:2/60) owner Pim
Protocol Mld
Type: Local
Interfaces: 1000 registered, 1000 owned
Registered interfaces:
ATM2/0.131 (31:2:2:22::2:2/604) local Mld owner Mld
Admission-bandwidth 2000000/10000000 bps
QoS Adjust 2000 bps
ATM2/0.132 (31:2:2:22::2:3/60) local Mld owner Mld
Chapter 5: Configuring IPv6 Multicast
175