Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 190

JunosE 11.3.x Multicast Routing Configuration Guide
Deleting Multicast Forwarding Entries
clear ipv6 mroute
Monitoring IPv6 Multicast Settings
show ipv6 mroute
168
If you set limits for both a port and interfaces on that port, the router uses the lower of
the two limits when determining whether or not an interface can accept any new MLD
groups. For example, if you specify an admission bandwidth limit of 2000000 bps for
the port and 3000000 bps groups for each interface, additional groups can only be
accepted until the port limit of 2000000 bps is reached.
You can clear one or more forwarding entries from the multicast routing table. However,
if you do so, the entries may reappear in the routing table if they are rediscovered.
Use to delete IPv6 multicast forwarding entries.
If you specify an *, the router clears all IP multicast forwarding entries.
If you specify the IPv6 address of a multicast group, the router clears all multicast
forward entries for that group.
If you specify the IPv6 address of a multicast group and the IPv6 address of a multicast
source, the router clears the multicast entry that matches that group and source.
Example
host1:boston#clear ipv6 mroute *
There is no no version.
See clear ipv6 mroute.
The commands in this sections display general information about the IPv6 multicast
configuration on the router.
Use to display information about all or specified multicast forwarding entries.
Specify a multicast group IPv6 address or both a multicast group IPv6 address and a
multicast source IPv6 address to display information about particular multicast
forwarding entries.
Use the summary option to see a summary rather than a detailed description.
Use the count option to display the number of multicast forwarding entries.
Use the statistics option to display statistics for packets received through all multicast
forwarding entries that the router has added to the multicast routing table and
established on the appropriate line modules.
Use the active option to display the active multicast routes with admission bandwidth
greater than the specified bandwidth threshold. The default is 4000 bps.
Field descriptions
Copyright © 2010, Juniper Networks, Inc.