Before You Begin
Enabling PIM on a VR
router pim
Disabling PIM on a VR
pim disable
Copyright © 2010, Juniper Networks, Inc.
NOTE: IETF drafts are valid for only 6 months from the date of issuance.
They must be considered as works in progress. Please refer to the IETF
Web site at http://www.ietf.org for the latest drafts.
You can configure PIM on IPv4 and IPv6 interfaces. However, IPv6 does not support all
PIM configuration options. For information about configuring PIM on IPv6 interfaces, see
"Configuring PIM for IPv6 Multicast" on page 211.
By default, PIM is disabled. To enable PIM on a VR:
Enable multicast routing. (See "Enabling IP Multicast" on page 6.)
1.
Create a VR, or access an existing VR context.
2.
host1(config)#virtual-router boston
Create and enable PIM processing.
3.
host1:boston(config)#router pim
Use to create and enable PIM processing on a VR or to access Router Configuration
mode.
Example
host1:boston(config)#router pim
Use the no version to remove PIM from the VR.
See router pim.
To disable PIM processing on a router, use the pim disable command.
Use to disable PIM processing. By default, PIM processing is enabled.
Example
host1:boston(config-router)#pim disable
Use the no version to reenable PIM processing.
See pim disable.
Chapter 3: Configuring PIM for IPv4 Multicast
87