Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 53

Copyright © 2010, Juniper Networks, Inc.
Expires—Length of time that the (S,G) pair can be active, in days
hours:minutes:seconds format or never
RPF route—IP address and subnetwork mask of the RPF route
incoming interface—Type and specifier of the incoming interface for the RPF route
neighbor address—IP address of the neighbor
State/Owner—Owner of the route
Local—Route belonging to the local interface
Static—Static route
Other protocols—Route established by a protocol such as RIP or OSPF
Incoming interface list—List of incoming interfaces on the router. Details include:
Type of interface and its specifier
Action that the interface takes with packets: Accept or Discard
Multicast protocol that owns the interface
Outgoing interface list—List of outgoing interfaces on the router. Details include:
Type of interface and its specifier
Action that the interface takes with packets: Forward or Blocked (port-limit)
Protocol running on the interface: PIM, DVMRP, or IGMP
Amount of time that the interface has been active in this multicast forwarding
entry, in days hours:minutes:seconds format
Length of time that the interface can remain active in this multicast forwarding
entry, in days hours:minutes:seconds format or never
Counts—Number of types of source group mappings
(S, G)—Number of (S, G) entries
(* , G)—Number of (* , G) entries
Example 1—Constant bandwidth bit rate
host1#show ip mroute
IP Multicast Routing Table
(S, G) uptime d h:m:s
[Data rate: Kbps]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
[SPT Threshold: Kbps] [Threshold: Kbps]
Chapter 1: Configuring IPv4 Multicast
31