Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 254

JunosE 11.3.x Multicast Routing Configuration Guide
show ipv6 pim rp
232
Ver—Version of PIM running on the local interface
Mode—PIM mode running on the local interface; always PIM sparse mode
Nbr Count—Number of remote neighbors detected: 0 or 1
Hello Intvl—Time interval at which the interface sends hello messages to neighbors
DR Addr—Address of designated router
In interface—Type and identifier of the interface on which PIM router receives packets
from remote neighbor. For details about interface types and specifiers, see Interface
Types and Specifiers in JunosE Command Reference Guide.
Out interface—Type and identifier of the interface on which PIM router sends packets
to remote neighbor. For details about interface types and specifiers, see Interface
Types and Specifiers in JunosE Command Reference Guide.
Example
host1:boston#show ipv6 pim remote-neighbor
PIM RemoteNbr Table
RemoteNbr Addr OurEnd Addr
1001::1 2001::1
In interface : atm2/1.109
Out interface: atm2/1.108
See show ipv6 pim remote-neighbor
Use to display information about PIM group-to-RP mappings.
Specify the address of a group to view PIM group-to-RP mappings for a particular
group.
To display all group-to-RP mappings that the router has recorded, specify the mapping
keyword.
Field descriptions
Group—Prefix of the multicast group
RP—IP address of RP router for the multicast group
priority—This field is not functional
via—Method by which the RP router was assigned (static, BSR)
Example
host1:8#show ipv6 pim rp mapping
PIM Group-to-RP mapping(s)
Group(s) ff00::/12
RP ::122:1, priority 0,
Ver Mode Nbr
Count Intvl
2 Sparse 1
via static
Copyright © 2010, Juniper Networks, Inc.
Hello DR Addr
30 ::107:84