Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 264

JunosE 11.3.x Multicast Routing Configuration Guide
ipv6 pim rp-address....................................................218
ipv6 pim rp-candidate................................................218
ipv6 pim spt-threshold..............................................220
See also show ipv6 pim commands
J
join messages..................................................................83, 212
L
leave group membership messages......................44, 180
leaving an IP multicast group.............................................44
leaving an IPv6 multicast group......................................180
limiting IGMP groups on interfaces..................................55
limiting MLD groups on interfaces.................................190
liveness detection
RIP and BFD.........................................................106, 224
M
M-BONE (multicast backbone of the Internet).........123
manuals
comments on..................................................................xxi
MDT (Multicast Distribution Tree)
creating with default MDT..........................................94
mdt commands
mdt-data-delay............................................................103
mdt-data-holddown..................................................103
mdt-data-timeout.......................................................104
mdt-interval...................................................................104
metric
DVMRP.............................................................................130
MLD (Multicast Listener Discovery)...............................179
configuring......................................................................184
disabling..........................................................................194
enabling..................................................................183, 184
limiting groups on interfaces...................................190
monitoring.......................................................................194
performing host functions.......................................205
removing..........................................................................194
specifying version................................................162, 184
mld disable command........................................................194
MLD proxy...............................................................................204
configuring.....................................................................205
enabling..........................................................................205
monitoring......................................................................207
version.............................................................................204
mrinfo requests, support for...............................................30
mtrace command..................................................................40
242
multicast
IP. See IP multicasting
IPv6. See IPv6 multicast
Multicast Distribution Tree. See MDT
multicast group port limit command......................56, 191
Multicast Listener Discovery. See MLD
multicast VPNs
creating with data MDTs.............................................95
creating with the default MDT..................................94
overview............................................................................94
N
neighbors, DVMRP................................................................124
notice icons...............................................................................xix
P
PIM (Protocol Independent Multicast).................79, 226
displaying events................................................109, 226
enabling
on a virtual router.........................................87, 215
on an interface..............................................88, 216
monitoring.....................................................30, 109, 226
removing................................................................108, 225
resetting counters and mappings................108, 226
using with DVMRP................................................88, 127
using with IGMP.............................................................88
using with MLD..............................................................216
See also PIM dense mode, PIM sparse mode,
PIM sparse-dense mode
PIM dense mode.....................................................................80
See also PIM
pim disable command.................................................87, 215
PIM SM. See PIM sparse mode
PIM sparse mode............................................................82, 212
configuring auto-RP router........................................90
joining groups.................................................................212
pruning..............................................................................212
remote neighbors, configuring........................94, 220
setting a threshold..............................................94, 220
timers.........................................................................84, 212
PIM sparse-dense mode .....................................................79
configuring auto-RP router........................................90
overview............................................................................85
PIM SSM (PIM source-specific multicast)
enabling..................................................................105, 223
requirements for IGMPv3..........................................105
requirements for MLDv2............................................223
Protocol Independent Multicast. See PIM
prune messages...............................................................81, 212
Copyright © 2010, Juniper Networks, Inc.