Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 86

Software for e series broadband services routers multicast routing configuration guide
Table of Contents

Advertisement

JunosE 11.3.x Multicast Routing Configuration Guide
show ip igmp interface
64
0 excluded
Source-groups: 6 included, 0 excluded
See show ip igmp groups.
Use to display IGMP information for interfaces on which you enabled IGMP.
Specify the brief keyword to see a summary of the information.
Specify the count keyword to see the number of IGMP interfaces.
Specify the group address keyword to see information for interfaces that belong to
that group.
Field descriptions
Interface—Type of interface and interface specifier. For details about interface types
and specifiers, see Interface Types and Specifiers in JunosE Command Reference
Guide.
address—IP address of the interface
Administrative state—Status of the interface in the software: enabled or disabled
Operational state—Physical status of the interface: enabled or disabled
Version—IGMP version
State—Function of the interface: querier or nonquerier
Query Interval—Time interval in seconds at which this interface sends query messages
Other querier present interval—Time in seconds that the interface waits before
declaring itself as the querier
Maximum response time—Time interval, in tenths of a second, during which this
interface waits for a host to respond
Last member query interval—Time, in tenths of a second, that this interface waits
before sending a new query to a host that sends a group leave message
Robustness—Number of times this interface sends IGMP messages
Information about whether the interface accepts IGMP reports from hosts on any
subnetwork
Interface defaults to global promiscuous mode—Interface uses the setting of the
igmp promiscuous command to determine whether it accepts IGMP reports from
hosts on any subnetwork
Information about standard IP access lists configured with the ip igmp access-group
command
Inbound access group—Access list specified
No inbound access group—No access list specified
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents