Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 133

show ip pim auto-rp
host1:1# show ip pim auto-rp
This PIM router is _not_ an Auto RP mapping agent.
PIM AutoRP candidate RP mapping(s)
Candidate RP 122.0.0.1
Group(s) 224.0.0.0/4, AutoRP, ttl 64, interval 60, from access List 1
Candidate RP 122.0.0.1
Group(s) 224.0.1.39/32 (negative), AutoRP, ttl 64, interval 60, from access List 1
Copyright © 2010, Juniper Networks, Inc.
Join filter—Name of the join filter access-list (if configured) for this PIM router
Designated Router Priority—Designated router priority value
Example
host1:1#show ip pim
Default PIM Version: 2
Default Domain Id: 0
Default Hello Period: 30
Default Hello HoldTime: 105
Join-Prune Interval: 100
Join-Prune Holdtime: 350
Keepalive Period: 210
Assert Time: 210
Register Suppression Time: 60
Register Probe Time: 5
Register TTL: 64
SSM enabled, range default
Sparse-Mode Graceful Restart Duration: 30
Graceful restart is complete (timer 0 seconds)
Join filter, access-list bronze
Designated Router Priority: 2
See show ip pim.
Use to display information about RP routers and the RP mapping agent in a PIM sparse
mode environment.
Field descriptions
Configured with ttl—Number of hops for which the RP discovery message is valid
Using interface addr—IP address of the interface from which the router sends RP
discovery messages
interval—Time interval, in seconds, at which the router sends RP discovery messages
PIM AutoRP candidate RP mapping(s)—Routers that the RP mapping agent is
evaluating to determine an RP router for this interface
Example 1
host1:1#show ip pim auto-rp
This PIM router is an Auto RP mapping agent.
Configured with ttl 64
[ Using interface addr 121.0.0.1, interval 60 ].
PIM AutoRP candidate RP mapping(s)
Example 2
Chapter 3: Configuring PIM for IPv4 Multicast
111