Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 95

ip igmp-proxy
ip igmp-proxy unsolicited-report-interval
ip igmp-proxy V1-router-present-time
Copyright © 2010, Juniper Networks, Inc.
Use to enable IGMP proxy on an interface.
The interface for which you enable IGMP proxy is the upstream interface.
NOTE: You can enable only one upstream interface.
You can specify either IGMP proxy version 2 or 3. The default is version 2.
Example
host1(config)#ip multicast-routing
host1(config-if)#ip igmp-proxy
Use the no version to disable IGMP proxy on an interface.
See ip igmp-proxy.
Use to specify the interval, in tenths of a second, at which the upstream interface
transmits unsolicited reports.
NOTE: Issue this command only on the upstream interface. Otherwise, this
command has no effect.
Example
host1(config-if)#ip igmp-proxy unsolicited-report-interval 600
Use the no version to transmit unsolicited reports using the default value,
400 tenths of a second.
See ip igmp-proxy unsolicited-report-interval
Use to specify how long, in seconds, the router calculates an IGMPv1 querier router to
exist on the subnetwork after the router receives an IGMP V1 query on this interface.
NOTE: Issue this command only on the upstream interface. Otherwise, this
command has no effect.
Example
host1(config-if)#ip igmp-proxy V1-router-present-time 600
Use the no version to set the time to the default value, 10 seconds.
See ip igmp-proxy V1-router-present-time
Chapter 2: Configuring IGMP
73