Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 136

JunosE 11.3.x Multicast Routing Configuration Guide
host1:PE1#show ip pim data-mdt senders summary
VRF S/R C-Group
---- ------- ---------
PE11 Sender 225.1.1.1
PE12 Sender 225.1.1.1
Counts: 2 senders, 0 receivers, total 3.
show ip pim dense-mode sg-state
114
Example 3—Displays a summary of data MDT senders
C-Source P-Group
----------- ---------
10.11.0.100 235.0.1.1
10.12.0.100 235.0.1.2
Example 4—Displays the number of data MDT senders and receivers
host1:PE1#show ip pim data-mdt count
Counts: 2 senders, 1 receivers, total 3.
See show ip pim data-mdt.
Use to display information for each (Source, Group) pair for PIM dense mode.
Field descriptions
(Source, Group) pair—IP addresses of multicast source and group
EntryExpires—Time until the (S,G) pair entry expires
RPF Route—Reverse-path forwarding route
IIF—IP address of incoming interface
UpNbr—IP address of upstream neighbor
Pruned Oifs—Outgoing interfaces that have been pruned
Address—IP address of outgoing interface
IfId—Index of the interface
Pruned due to—Reason for prune: assert or explicit prune
Pruned time remaining—Time in seconds until the prune expires
Example
host1:8#show ip pim dense-mode sg-state
PIM DM route table and pruned oif information
<122.0.0.1, 224.0.1.39>
RPF Route: 122.0.0.0/255.0.0.0
Pruned Oifs:
Address: 108.0.8.5
Pruned due to assert
Pruned time remaining 129
<130.0.0.2, 224.0.1.39>
RPF Route: 130.0.0.0/255.0.0.0
Pruned Oifs:
Address: 108.0.8.5
Pruned due to assert
Pruned time remaining 130
<121.0.0.1, 224.0.1.40>
P-Source MTI
-------- ---------------
1.1.1.1 TUNNEL gre:mvpn-dynamic-1
1.1.1.1 TUNNEL gre:mvpn-dynamic-2
EntryExpires: 99
IIF: 107.0.8.4
IfId: 95
EntryExpires: 100
IIF: 107.0.8.4
IfId: 95
EntryExpires: 102
Copyright © 2010, Juniper Networks, Inc.
UpNbr: 107.0.4.8
UpNbr: 107.0.4.8