Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 184

JunosE 11.3.x Multicast Routing Configuration Guide
encapsulation vlan
ipv6 mld version
ipv6 multicast ioa-packet-replication
162
c. Create a VLAN subinterface.
d. Assign a VLAN ID.
e. Configure an unnumbered IPv6 interface.
f. Enable MLD on the interface with only multicast-data-forwarding capability.
host1(config)#interface gigabitEthernet 2/8
host1(config-if)#encapsulation vlan
host1(config-if)#interface gigabitEthernet 2/8.1
host1(config-if)#vlan id 1
host1(config-if)#ipv6 unnumbered loopback 0
host1(config-if)#ipv6 mld version passive
Configure an IPv6 interface to redirect egress multicast traffic to port 8.
2.
a. Create a VLAN subinterface.
b. Assign a VLAN ID.
c. Assign an IPv6 address.
d. Configure the interface to redirect egress multicast traffic to port 8.
host1(config)#interface gigabitEthernet 2/0.101
host1(config-if)#vlan id 1
host1(config-if)#ipv6 address 1::1/64
host1(config-if)#ipv6 multicast ioa-packet-replication gigabitEthernet 2/8.1
Use to configure VLAN as the encapsulation method for the interface.
Example
host1(config-if)#encapsulation vlan
Use the no version to disable VLAN on an interface.
See encapsulation vlan.
Use to set the MLD version (1 or 2) for the interface.
Example
host1:boston(config-if)#ipv6 mld version 2
Use the no version to set the version to the default, MLDv2.
See ipv6 mld version.
Use to configure hardware multicast packet replication on port 8 of a high-density
Ethernet module.
Example
Copyright © 2010, Juniper Networks, Inc.