Table of Contents
Advertisement
Before You Begin
Enabling and Disabling PIM on a VR
ipv6 router pim
pim disable
Copyright © 2010, Juniper Networks, Inc.
NOTE: IETF drafts are valid for only 6 months from the date of issuance.
They must be considered as works in progress. Please refer to the IETF
Web site at
http://www.ietf.org
You can configure multicast on IPv4 and IPv6 interfaces.
For information about configuring IP interfaces, see Configuring IP in theJunosE IP, IPv6,
and IGP Configuration Guide. For information about configuring IPv6 interfaces, see
Configuring IPv6 in the JunosE IP, IPv6, and IGP Configuration Guide.
For information about configuring PIM on IPv4 interfaces, see "Configuring PIM for IPv4
Multicast" on page 79.
By default, PIM is disabled. To enable PIM on a VR:
Enable multicast routing.
1.
Create a VR, or access the VR context.
2.
Create and enable PIM processing.
3.
host1(config)#virtual-router boston
host1:boston(config)#ipv6 router pim
To disable PIM processing on a router, use the pim disable command.
Use to create and enable PIM processing on a VR or to access Router Configuration
mode.
Example
host1:boston(config)#ipv6 router pim
Use the no version to remove PIM from the VR.
See ipv6 router pim.
Use to disable PIM processing. By default, PIM processing is enabled.
Example
host1:boston(config-router)#pim disable
Use the no version to reenable PIM processing.
See pim disable.
Chapter 7: Configuring PIM for IPv6 Multicast
for the latest drafts.
215
Advertisement
Table of Contents
