Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 248

JunosE 11.3.x Multicast Routing Configuration Guide
ipv6 router pim
Resetting PIM Counters and Mappings
clear ipv6 pim interface
clear ipv6 pim remote-neighbor
Monitoring PIM
226
Use to create and enable PIM processing on a VR or to access Router Configuration
mode.
Example
host1:boston(config)#no ipv6 router pim
Use the no version to remove PIM from the VR.
See ipv6 router pim.
You can use the clear ipv6 pim commands to reset PIM counters and mappings.
Use to clear the counters for multicast packet statistics on all interfaces or a specified
interface.
Specify an interface type and identifier, such as atm 3/0 to clear the counters on that
interface. For details about interface types and specifiers, see Interface Types and
Specifiers in JunosE Command Reference Guide.
If you do not specify an interface, the router clears the counters on all interfaces.
Example
host1#clear ipv6 pim interface atm 3/0.5 count
There is no no version.
See clear ipv6 pim interface.
Use to clear the counters for remote neighbor statistics on all interfaces or the specified
interface.
Specify the IP address of an interface to clear the counters for that interface.
If you do not specify an interface, the router clears the counters on all interfaces.
Example
host1#clear ipv6 pim remote-neighbor 1001::1 count
There is no no version.
See clear ipv6 pim remote-neighbor.
You can display information about PIM events and parameters.
Copyright © 2010, Juniper Networks, Inc.