Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 157

show ip dvmrp
Copyright © 2010, Juniper Networks, Inc.
There is no no version.
See baseline ip dvmrp.
Use to display DVMRP information for a VR.
Field descriptions
Dvmrp Administrative State—State of DVMRP in the software: Enabled or Disabled
Mcast Administrative State—State of multicasting in the software: Enabled or
Disabled
Dvmrp Version—Version of DVMRP with which this software is compatible
GenerationID—A number the router generates each time it reboots; when the number
changes, neighbors discard all information previously learned from the router
Number of Routes—Number of routes in the DVMRP routing table
Number of Triggered Routes—Number of routes waiting to be advertised, because
a parameter for the route changed
Reachable Routes—Number of routes that the router can currently reach
Route-hog-notification—Number of DVMRP routes that the router can record before
it generates a system log warning message
Route-limit—Maximum number of routes that the router can advertise on each
interface
Send-S32-Prunes-Only—Indicator of whether the router sends only S-32 prunes
true—Router sends only S-32 prunes and grafts to ensure compatibility with other
protocols, such as PIM
false—Router sends S-32 and S/Prefix grafts and prunes
Example
host1:boston>show ip dvmrp
Routing Process DVMRP - Distance Vector Multicast Routing Protocol
Dvmrp Administrative State:
Multicast Administrative State:
Dvmrp Version:
Generation ID:
Number of Routes:
Number of Triggered Routes:
Reachable Routes:
route-hog-notification:
route-limit:
Send-S32-Prunes-Only:
unicastRoutingOnly:
Graceful Restart Duration:
Graceful Restart is:
Chapter 4: Configuring DVMRP
Enabled
Enabled
3.255
0x46828e2b
2
0
2
10000
7000
true
false
60
complete (timer 0 seconds)
135