Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 228

JunosE 11.3.x Multicast Routing Configuration Guide
ipv6 mld-proxy unsolicited-report-interval
ipv6 mld-proxy version
Setting the MLD Proxy Baseline
baseline ipv6 mld-proxy interface
206
You can specify either MLD proxy version 1 or 2. The default is version 2.
Example
host1(config-if)#ipv6 mld-proxy
Use the no version to disable MLD proxy on an interface.
See ipv6 mld-proxy.
Use to specify, in tenths of a second, how often the upstream interface should transmit
unsolicited reports.
NOTE: Issue this command only on the upstream interface. Otherwise, this
command has no effect.
Example
host1(config-if)#ipv6 mld-proxy unsolicited-report-interval 600
Use the no version to transmit unsolicited reports using the default value, 100-tenths
of a second (10 seconds).
See ipv6 mld-proxy unsolicited-report-interval
Use to set the MLD proxy version for the interface.
Example
host1(config-if)#ipv6 mld-proxy version 1
Use the no version to set the version to its default value, MLDv2.
See ipv6 mld-proxy version.
You can set the counters for the numbers of queries received and reports sent on the
upstream interface to zero. This feature allows you to establish a reference point for MLD
proxy statistics.
Copyright © 2010, Juniper Networks, Inc.