Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 30

JunosE 11.3.x Multicast Routing Configuration Guide
8
Prefix—Value of the logical AND of the IP address of the destination network and
the subnet address
Length—Length of the subnet mask in bits
Type—Protocol type for the interface
Connect—Subnet directly connected to the interface
Static—Static route
protocol-name—Route learned through the named protocol
Next Hop—IP address of the next hop for this route
Dist—Distance configured for this route
Met—Learned or configured cost associated with this route
Intf—Type of interface and interface specifier for the next hop. For details about
interface types and specifiers, seeInterface Types and Specifiers in JunosE Command
Reference Guide.
Example 1
host1#show ip rpf-route
Protocol/Route type codes:
I1- ISIS level 1, I2- ISIS level2,
I- route type intra, IA- route type inter, E- route type external,
i- metric type internal, e- metric type external,
O- OSPF, E1- external type 1, E2- external type2,
N1- NSSA external type1, N2- NSSA external type2
L- MPLS label, V- VR/VRF, *- indirect next-hop
Prefix/Length
-------------
10.10.0.112/32
10.1.1.0/24
25.25.25.25/32
Example 2
host1#show ip rpf-route static
Protocol/Route type codes:
I1- ISIS level 1, I2- ISIS level2,
I- route type intra, IA- route type inter, E- route type external,
i- metric type internal, e- metric type external,
O- OSPF, E1- external type 1, E2- external type2,
N1- NSSA external type1, N2- NSSA external type2
L- MPLS label, V- VR/VRF, *- indirect next-hop
Prefix/Length Type
------------- ----
10.10.0.112/32 Static 192.168.1.1
See show ip rpf-route.
Type Next Hop Dist/Met
---- -------- --------
Static 192.168.1.1
Connect 10.1.1.1
Connect 25.25.25.25
Next Hop Dist/Met
-------- --------
1/1
Copyright © 2010, Juniper Networks, Inc.
Intf
------
1/1 fastEthernet0/0
0/1 atm3/0.100
0/1 loopback0
Intf
--------------
fastEthernet0/0