Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 192

JunosE 11.3.x Multicast Routing Configuration Guide
show ipv6 mroute active
170
(* ,G)—Number of (* ,G) entries
Example
host1#show ipv6 mroute
IP Multicast Routing Table
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(10:0:0:1:1::, ff0e::1) uptime 0 01:04:12
RPF route: 10:0:0:1::/64, incoming interface ATM2/3.1001
neighbor 10:0:0:1::1, owner Local
Incoming interface list:
ATM2/3.1001 (10:0:0:1::1/64), Accept/Pim (RPF IIF)
Outgoing interface list:
ATM2/0.200 (21:2:2:21::2:1/60), Forward/Pim, 0 01:04:12/never
(10:0:0:1:2::, ff0e::1) uptime 0 01:04:12
RPF route: 10:0:0:1::/64, incoming interface ATM2/3.1001
neighbor 10:0:0:1::1, owner Local
Incoming interface list:
ATM2/3.1001 (10:0:0:1::1/64), Accept/Pim (RPF IIF)
Outgoing interface list:
ATM2/0.200 (21:2:2:21::2:1/60), Forward/Pim, 0 01:04:12/never
Counts: 2 (S, G) entries
0 (*, G) entries
See show ipv6 mroute.
Use to display the active multicast routes with admission bandwidth greater than the
specified bandwidth threshold.
The default is 4000 bps.
Field descriptions
See the show ipv6 mroute command and the show ipv6 mroute summary
command for descriptions of all fields.
Example 1—Displays active multicast routes with bandwidth above 10000 bps
host1#show ipv6 mroute active 10000
Active IP Multicast Routes >=10000 bps
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
Copyright © 2010, Juniper Networks, Inc.