Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 198

JunosE 11.3.x Multicast Routing Configuration Guide
show ipv6 multicast protocols brief
show ipv6 multicast routing
176
Admission-bandwidth 0/10000000 bps
QoS Adjust 0 bps
ATM2/0.133 (31:2:2:22::2:4/60) local Mld owner Mld
Admission-bandwidth 8000000/10000000 bps, 2 Blocked OIFs
QoS Adjust 0 bps
...
Count: 2 protocols
See show ipv6 multicast protocols.
Use to display a summary of information about multicast protocols enabled on the
router.
Field descriptions
Protocol—Name of the multicast protocol
Registered Interfaces—Number of interfaces on which the protocol is configured.
Owned Interfaces—Number of interfaces that a protocol owns. If you configure only
MLD on an interface, MLD owns the interface. However, if you configure MLD and
PIM on the same interface, PIM owns the interface.
Type—Mode of the multicast protocol
For PIM—Sparse
For MLD—Local
Count—Number of multicast protocols on the VR
Example
host1#show ipv6 multicast protocols brief
Protocol Registered Owned
Interfaces Interfaces
--------- ---------- ---------- -------------------
Pim 1
Mld 1
Count: 2 protocols
See show ipv6 multicast protocols.
Use to display information about the status of IPv6 multicast on the VR.
Example
host1#show ipv6 multicast routing
Multicast forwarding is enabled on this router
Multicast graceful restart is complete (timer 0 seconds) on this router
Multicast cache-miss processing is enabled on this router
Multicast forwarding is enabled on this router
Multicast graceful restart is complete (timer 0 seconds) on this router
Multicast cache-miss processing is enabled on this router
Type
1 Sparse
1 Local
Copyright © 2010, Juniper Networks, Inc.