Monitoring MLD Proxy
show ipv6 mld-proxy
show ipv6 mld-proxy groups
Copyright © 2010, Juniper Networks, Inc.
Use to set the counters for the numbers of queries received and reports sent on the
upstream interface to zero.
NOTE: Issue this command only on the upstream interface. Otherwise, this
command will have no effect.
Example
(host1)#baseline ipv6 mld-proxy interface
There is no no version.
See baseline ipv6 mld-proxy interface.
To display MLD proxy parameters, use the following show commands.
Use to display MLD proxy parameters for a VR.
Field descriptions
Routing Process—MLD proxy protocol
Administrative state—State of MLD proxy in the software
Operational state—Operational state of MLD proxy: enabled or disabled
total interfaces—Number of MLD proxy interfaces on the VR; currently only one
upstream interface per VR
state—Operational state of the MLD proxy interfaces: enabled or disabled
multicast group—Number of multicast groups associated with MLD proxy interfaces
Example
host1#show ipv6 mld-proxy
Routing Process MLD Proxy, Administrative state enabled, Operational state
enabled
total 1 upstream interface, state enabled
1 multicast group
See show ipv6 mld-proxy.
Use to display information about multicast groups that MLD proxy reported.
Field descriptions
Chapter 6: Configuring Multicast Listener Discovery
207