Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 160

JunosE 11.3.x Multicast Routing Configuration Guide
138
Neighbor upTime/UpTime—Length of time, in seconds, that this router has been a
neighbor
Neighbor Major Version/Maj—Major number of the DVMRP version on the neighbor
Neighbor Minor Version/Min—Minor number of the DVMRP version on the neighbor
Neighbor Capabilities/Cap—Capability of the neighbor
Prune/P—Ability to send prune messages
GenerationId/G—Ability to create a generation ID number
Mtrace/M—Ability to trace multicast routes
Netmask/N—Ability to send prunes and grafts with a network mask address
Neighbor State/State—Status of communications with the neighbor
Active—Router is able to communicate with this neighbor
Down—Neighbor is down
Ignoring—Router is not accepting messages from this neighbor
Oneway—Router is receiving messages from the neighbor, but the neighbor does
not include the router's IP address in the messages. This state can indicate a
starting transition, or a problem.
Generation ID—Number that the neighbor generates each time it boots; when the
number changes, the VR discards all information previously learned from the router.
Routes Received—Number of routes received from this neighbor
Bad Routes Received—Number of bad routes received from this neighbor
Bad Packets Received—Number of bad packets received from this neighbor
Example 1
host1:boston# show ip dvmrp neighbor
Neighbor Address:
Interface:
Neighbor upTime:
Neighbor Major Version:
Neighbor Minor Version:
Neighbor Capabilities:
Neighbor State:
Geneneration ID:
Routes Received:
Bad Routes Received
Bad Packets Received:
Example 2
host1:v3#show ip dvmrp neighbor brief
Interface
14.0.0.1
atm5/0.14
28
3
255
Prune GenerationId
Active
0x3a13fbc2
1
0
0
NbrAddress UpTime Maj Min Cap
Copyright © 2010, Juniper Networks, Inc.
Mtrace NetMask
State