Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 126

JunosE 11.3.x Multicast Routing Configuration Guide
mdt-data-timeout
mdt-interval
set threshold
tunnel group-address-pool
104
Example
host1(ip-pim-data-mdt-config)#mdt-data-holddown 200
Use the no version to return to the default.
See mdt-data-holddown.
Use to configure the time in seconds before the flow leaves the data MDT group.
The default is 180.
Example
host1(ip-pim-data-mdt-config)#mdt-data-timeout 160
Use the no version to return to the default.
See mdt-data-timeout.
Use to configure the time in seconds between successive MLD join TLV messages.
The default is 60.
Example
host1(ip-pim-data-mdt-config)#mdt-interval 80
Use the no version to return to the default.
See mdt-interval.
Use to configure a threshold value for multicast VPN applications, including default
MDT and data MDT.
Example
host1(config)#set threshold 30
Use the no version to remove the threshold.
See set threshold.
Use to configure a group address pool for a data MDT tunnel.
Example
host1(ip-pim-data-mdt-config)#tunnel group-address-pool dataMDT1
Use the no version to delete the group address pool.
See tunnel group-address-pool.
Copyright © 2010, Juniper Networks, Inc.