Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 252

JunosE 11.3.x Multicast Routing Configuration Guide
host1# show ipv6 pim interface
PIM Interface Table
Interface Addr Interface
101::1 ATM2/0.100
102::1 ATM2/0.101
103::1 ATM3/0.102
230
Specify the count keyword to view the number of multicast packets that the interface
has sent and received.
Field descriptions
Interface Addr—IPv6 address of the interface
Interface Name—Type and identifier of the interface. For details about interface
types and specifiers, see Interface Types and Specifiers in JunosE Command Reference
Guide.
Ver—Version of PIM running on this interface
Mode—PIM mode running on this interface: Sparse
Nbr Count—Number of neighbors connected to this interface
Hello Intvl—Time interval at which the interface sends hello messages to neighbors
J/P Interval—Total number of join/prune message interval, in seconds, at which the
interface sends the join/prune messages
DR Address—Address of the designated router
SM—Number of PIM sparse mode interfaces
enabled—Number of interfaces administratively enabled
disabled—Number of interfaces administratively disabled
DR Pri— Designated router priority value
ControlPkt Count In | Out—PIM messages received on and sent from this interface
Hello—Number of hello messages
JoinPrune—Total number of join and prune messages
Assert—Number of assert messages
Example 1
State Ver Mode Nbr
Count
Up 2 Sparse 1
Up 2 Sparse 1
Up 2 Sparse 1
Example 2
host1#show ipv6 pim interface summary
PIM Interface Summary
SM: 0, 0 enabled, 0 disabled
Example 3
Hello J/P DR DR Addr
Intvl Intvl Pri
30 150 5 101::2
30 100 2 102::2
30 100 2 103::1
Copyright © 2010, Juniper Networks, Inc.
JoinFilter
-
silver
gold