Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 250

JunosE 11.3.x Multicast Routing Configuration Guide
show ipv6 pim bsr
228
Keepalive Period—Time SG join state is maintained in the absence of SG Join message
Assert Time—Period after last assert before assert state is timed out
Register Suppression Time—Period during which a designated router stops sending
registers to the RP
Register Probe Time—Time before register suppression time (RST) expires when a
designated router might send a NULL-Register to the RP
Register TTL—TTL value (in PIM register packets) originated by this PIM router
SSM—State of SSM on this PIM router (enabled or disabled)
range—Default SSM group range or name of the access list specifying the range
Join filter—Name of the join filter access-list (if configured) for this PIM router
Designated Router Priority—Designated router priority value
Example
host1:1#show ipv6 pim
Default PIM Version: 2
Default Domain Id: 0
Default Hello Period: 30
Default Hello HoldTime: 105
Join-Prune Interval: 100
Join-Prune Holdtime: 350
Keepalive Period: 210
Assert Time: 210
Register Suppression Time: 60
Register Probe Time: 5
Register TTL: 64
SSM enabled, range default
Sparse-Mode Graceful Restart Duration: 30
Graceful restart is complete (timer 0 seconds)
Join filter, access-list bronze
Designated Router Priority: 2
See show ipv6 pim.
Use to display BSR information and the group prefixes for which the local router is a
candidate RP in a PIM sparse mode environment.
Field descriptions
Candidacy—Whether or not the router is a candidate BSR
Configured on—Interface on which the router is configured
address—Address of the router
hashMaskLen—Hash mask length
priority—Priority of the router
Copyright © 2010, Juniper Networks, Inc.