Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 251

show ipv6 pim interface
Copyright © 2010, Juniper Networks, Inc.
period—Time between bootstrap messages
Elected BSR—" this router" or IP address of the elected bootstrap router
next BSM—If BSR is " this router," time until the next bootstrap message is sent
expires in—If BSR is not " this router," time until the elected BSR expires if no bootstrap
messages are received
Local candidate RP mapping(s)—Routers that the mapping agent is evaluating to
determine an RP router for this interface
Example 1—On a router that is the elected BSR
host1:1#show ipv6 pim bsr
This PIM router is a Candidate BSR.
Configured on intf ATM3/0.101, address: ::107:9
hashMaskLen 30, priority 2, period 60 seconds.
Elected BSR is this router, next BSM in 3 seconds.
Local candidate RP mapping(s):
Candidate RP ::107:9
::108:86, BSR, hold-time 150, interval 60, priority 192
::108:87, BSR, hold-time 150, interval 60, priority 192, from access-list
acl
::108:88, BSR, hold-time 150, interval 60, priority 192, from access-list
acl
Example 2—On a router that is a candidate BSR
host1:1#show ipv6 pim bsr
This PIM router is a Candidate BSR.
Configured on intf ATM3/0.100, address: ::107:9
hashMaskLen 30, priority 2, period 60 seconds.
Elected BSR is ::107:8 (priority 0), expires in 73 seconds.
Example 3—On a router that is not a candidate BSR
host1:1#show ipv6 pim bsr
This PIM router is not a Candidate BSR.
Elected BSR is ::107:9 (priority 0), expires in 73 seconds.
See show ipv6 pim bsr.
Use to display information about PIM interfaces.
Specify no keywords or variables to view information about all PIM interfaces.
Provide an interface type and specifier (such as atm 3/0) to display information about
that interface only. For details about interface types and specifiers, see Interface Types
and Specifiers in JunosE Command Reference Guide.
Specify the detail keyword to view detailed information for all PIM interfaces or for a
specified PIM interface.
Specify the summary keyword to view the number of configured, enabled, and disabled
PIM sparse-mode interfaces.
Chapter 7: Configuring PIM for IPv6 Multicast
229