Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 57

show ip mroute summary
Copyright © 2010, Juniper Networks, Inc.
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(10.0.1.9, 225.1.1.1) uptime 0 00:00:23
Admission bandwidth: 2000000 bps
QoS bandwidth: 2000000 bps
RPF route: 10.0.0.0/8, incoming interface ATM2/1.200
neighbor 21.1.1.1, owner Netmgmt
Incoming interface list:
ATM2/1.200 (21.2.2.2/8), Accept/Pim (RPF IIF)
Outgoing interface list:
ATM2/1.300 (31.2.2.2/8), Blocked (port-adm-limit)/Pim, 0
00:00:23/never
Statistics:
Received : 23 pkts, 1472 bytes
Forwarded : 0 pkts, 0 bytes
Rcvd on OIF: 0 pkts
Counts: 1 (S, G) entries
0 (*, G) entries
See show ip mroute.
See statistics.
Use to display a summary of all or specified multicast routes.
Specify a multicast group IP address or both a multicast group IP address and a
multicast source IP address to display information about a particular multicast
forwarding entry.
Field descriptions
Group Address—IP address of the multicast group
Source Address—IP address of the multicast source
RPF route—IP address and network mask of the RPF route
RPF Iif —Type and identifier for the incoming interface for the RPF route
#Oifs—Number of outgoing interfaces
Counts—Numbers of types of (S,G) pairs
(S,G)—Number of (S,G) entries
(* ,G)—Number of (* ,G) entries
Example
host1#show ip mroute summary
IP Multicast Routing Table
Chapter 1: Configuring IPv4 Multicast
35