Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 58

JunosE 11.3.x Multicast Routing Configuration Guide
show ip multicast protocols
36
Group Address Source Address
--------------- --------------- ---------
224.0.1.39 52.1.1.1
224.0.1.40 51.1.1.1
Counts: 2 (S, G) entries
0 (*, G) entries
See show ip mroute.
Use to display information about multicast protocols enabled on the router.
Use the brief option to display a summary of information rather than a detailed
description.
Field descriptions
Multicast Protocols—Multicast protocols on this router
Protocol—Name of the multicast protocol
Type—Mode of the multicast protocol
For DVMRP—Dense
For PIM—Sparse, Dense, or Sparse-Dense
For IGMP—Local
Interfaces
registered—Number of interfaces on which the protocol is configured
owned—Number of interfaces that a protocol owns. If you configure only IGMP on
an interface, IGMP owns the interface. However, if you configure IGMP and either
PIM or DVMRP on the same interface, PIM or DVMRP owns the interface.
Registered interfaces—Information about interfaces on which the protocol is
configured:
Types and specifiers of interfaces. For details about interface types and specifiers,
see Interface Types and Specifiers in JunosE Command Reference Guide.
Protocols configured on the interface and the protocol that owns the interface. If
you configure only IGMP on an interface, IGMP owns the interface. However, if you
configure IGMP and PIM or DVMRP on the same interface, PIM or DVMRP owns
the interface.
Admission-bandwidth—Actual admission bandwidth/configured admission bandwidth
(in bps)
QoS Adjust—Bandwidth of QoS adjustment, in bps
Count—Number of multicast protocols on the VR
Active <S,G> count—Number of active S,G data streams on the interface
RPF route RPF Iif
-------------
51.1.1.1/32 Register IIF
51.1.1.1/32 loopback1
Copyright © 2010, Juniper Networks, Inc.
#Oifs
----
0
1