Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 139

show ip pim rp
Copyright © 2010, Juniper Networks, Inc.
Expires—Time available for the neighbor to send a hello message to the interface.
If the neighbor does not send a hello message during this time, it no longer is a
neighbor.
Ver—Version of PIM that the neighbor is running
Mode—PIM mode that the neighbor is using: Sparse, Dense, or SparseDense
BFD—BFD status: up or down
Example
host1#show ip pim neighbor
Neighbor
Addr Interface Name
-------- ---------------
1.1.1.1 FastEthernet1/1
Neighbor
Addr Interface Name
-------- ---------------
1.1.1.1 FastEthernet1/1
Neighbor
Addr Interface Name
-------- ---------------
1.1.1.1 FastEthernet1/1
See show ip pim neighbor.
Use to display information about PIM group-to-RP mappings.
Specify the address of a group to view PIM group-to-RP mappings for a particular
group.
Specify the mapping keyword to display all group-to-RP mappings that the router has
recorded.
Field descriptions
Group(s)—Prefix of the multicast group
RP—IP address of RP router for the multicast group
priority—Priority of the router
via—Method by which the RP router was assigned: AutoRP, Static RP, or BSR
expiryTime—Time in seconds at which the RP mapping becomes invalid, unless the
mapping agent (access list) reassigns the RP router to this group
Example 1
host1:8#show ip pim rp mapping
PIM Group-to-RP mapping(s)
Group(s) 224.0.0.0/4
RP 122.0.0.1, priority 0,
Group(s) 224.0.1.39/32 (negative)
Chapter 3: Configuring PIM for IPv4 Multicast
Uptime Expires Ver
-------- -------- ---
00:02:49 00:01:27 2
Uptime Expires Ver
-------- -------- ---
00:03:16 00:01:30 2
Uptime Expires Ver
-------- -------- ---
00:00:07 00:01:39 2
via AutoRP, expiryTime 88
Mode BFD
------ ---
Sparse
Mode BFD
------ ---
Sparse up
Mode BFD
------ ----
Sparse down
117