Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 216

JunosE 11.3.x Multicast Routing Configuration Guide
Disabling and Removing MLD
mld disable
router mld
ipv6 router mld
Monitoring MLD
194
host1(config)#ipv6 mld explicit-tracking
Use the no version to disable explicit host tracking on the interface. Use the no version
with the disable-if-mld-detected keyword to revert to the default explicit host tracking
behavior.
See ipv6 mld explicit-tracking.
You can disable and reenable MLD on the VR. You can also remove MLD from the VR
and re-create it on the VR.
Use to disable MLD on a VR.
Example
host1(config)#virtual-router boston
host1:boston(config)#router mld
host1:boston(config-router)#mld disable
Use the no version to enable MLD on a VR.
See mld disable.
Use to create and enable MLD on a VR or to access MLD Router Configuration mode.
Example 1
host1(config)#virtual-router boston
host1:boston(config)#router mld
Example 2
host1(config)#virtual-router boston
host1:boston(config)#ipv6 router mld
Use the no version to delete MLD and MLD proxy from the VR.
See router mld.
See ipv6 router mld.
You can establish a reference point for MLD statistics by setting the statistics counters
to zero.
To display MLD parameters, use the show commands described in this section.
Copyright © 2010, Juniper Networks, Inc.