Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 191

Copyright © 2010, Juniper Networks, Inc.
(S,G)—IPv6 addresses of the multicast source and the multicast group
Admission bandwidth—Admission bandwidth (in bps)
QoS bandwidth—QoS bandwidth (in bps)
Uptime—Length of time that the (S,G) pair has been active, in days
hours:minutes:seconds format
Expires—Length of time for which the (S,G) pair will be active, in days
hours:minutes:seconds format
RPF Route—IPv6 address and prefix of the RPF route
Incoming interface—Type and specifier of the incoming interface for the RPF route
neighbor address—IPv6 address of the neighbor
owner—Owner of the route
Local—route belonging to the local interface
Static—Static route
Other protocols—Route established by a protocol
Incoming interface list—List of incoming interfaces on the router. Details include:
Type of interface and its specifier
Action that the interface takes with packets: accept or discard
Multicast protocol that owns the interface
Time that the interface has been active in this multicast forwarding entry, in days
hours:minutes:seconds format
Time that the interface will cease to be active in this multicast forwarding entry,
in days hours:minutes:seconds format
Outgoing interface list—List of outgoing interfaces on the router. Details include:
Type of interface and its specifier
Action that the interface takes with packets: forward
Protocol running on the interface: PIM or MLD
Time that the interface has been active in this multicast forwarding entry, in days
hours:minutes:seconds format
Time that the interface will cease to be active in this multicast forwarding entry,
in days hours:minutes:seconds format
Counts—Numbers of types of source group mappings
(S,G)—Number of (S,G) entries
Chapter 5: Configuring IPv6 Multicast
169